| |
600w RMS x 1 @ 4 ohm
- 800w RMS x 1 @ 2 ohm
- 1200w RMS x 1 ch @ 1 ohm
- Soft Start Sound: Yes
- Frequency Response: 15hz-300hz
- Damping factor: >260
- S/N ratio: >95 dB/min
- THD: 0.10%
- variable input level control: 0.2v - 6.0v
- input impedance: 47kOHM
- Diagnostic Indicator: Power/Protect
- Protection (DC, Short, Thermal, Overload): Yes
- variable low pass (mono 24dB): 35hz-250hz
- variable subsonic filter: 15hz-25hz
- bass boost at 45hz: 0 ~ 9dB
- Line Output: full range
- Unbalanced input ( RcA jack ): yes
- Balanced line input ( DIN ): yes
- Phone jack for remote control : yes
- Fuse Size: 2 x 40A
- Dimenesions: 17 x 2.25 x 10.4"
- Super Class D Amplifier topology
- Stable @ 1 ohm loads
- High Speed MOSFET Output Devices
- Focused Mass Aluminum Heat Sink
- PWM Power Supply
- Band Pass Capable Crossover
- Vario bass equalizer circuit
- variable 24dB subsonic filter
- Full range preamp outputs
- Remote bass level control included
- 2 gauge power & ground inputs
- 4 stage amplifier protection circuit
- wire concealing end panels
-
- American Accessories KIT-4
25ft RCA Interconnect high definition audio cable shielded w/Built-in remote/ground wire
- (1) Gold plated Agu Fuse 80Amp AND 4 Gauge Water Resistant Inline Fuse Holder AGU type
- 20ft 4 Gauge Red Power Wire
- 6ft 4 Gauge Split loom for cable protection and organization
- 35ft 12 Gauge OFC Speaker Cable
- 20ft 16 Gauge Blue remote turn on wire
- 4ft 4 Gauge Blue/Purple Ground Wire
- (5) Wire protectors to keep wire surround from being damaged
- Cable ties to organize and allow for a clean and efficient installation
- (4) 14-16 Gauge wire connectors for remote, speaker, and other cable connections
- (1) 10-12 Gauge butt connector for extending/crimping
- (2) 4 Gauge gold-plated connectors for ground and power connection to amplifier
- (1) 4 Gauge Gold ring terminal
- (2) 8-10 Gauge wire connectors for ground and power connection to amplifier
- (2) 14-16 Gauge butt connectors for extending/crimping
- (4) 10-12 Gauge speaker connectors for speaker wire connection to plate terminals
-
-
|
